Repairs · Service
Solar panel removal and refit for roof work
Solar panel removal for roof repairs or re-roofing is a job for a solar engineer, not your roofer. The system is isolated and disconnected, the panels are stored safely while the roof is done, then refitted, retested and switched back on. Panels can still produce a voltage in daylight when disconnected, so never try to remove them yourself or go on the roof.
Mon–Fri 9:00am–5:00pm · Clear written quote before any work starts
Talk to us about solar, batteries or repairs.
Call 0800 156 0191, Monday to Friday, 9:00am–5:00pm, or send us a message through our contact page.
MCS certified
NAPIT registered
TrustMark approved
Fully insured
England, Wales & southern Scotland
When
When panels need to come off.
We remove and refit panels on systems fitted by any installer, across England, Wales and southern Scotland.
- A new roof or re-tiling under the panels.
- Roof repairs or leaks around or under the array.
- Chimney, dormer or loft conversion work that reaches the panels.
- Storm or insurance repairs to the roof. See storm-damaged solar panels.
- Moving the panels to a different part of the roof.
- Only need one damaged panel swapped? See replacing a solar panel.
Why an engineer
Why it needs a solar engineer.
- Panels make electricity whenever there’s daylight. Disconnecting them safely means isolating the system and handling live DC connectors correctly.
- The connectors and cables must be matched and weatherproof when they go back together. Panel makers warn that incorrect connections can cause electric arcs, and that connectors of different brands mustn’t be joined. See isolation and earth faults explained.
- The system needs testing before it’s switched back on, and the results recorded.
- The roof fixings need refitting to suit the new roof, with the right hooks and flashings so they don’t cause leaks.
A roofer shouldn’t disconnect or reconnect the panels themselves.
How it works
How it works.
- Check the system first. We check it’s working and note the generation meter reading before anything comes off, so any existing fault is found now rather than blamed on the roof work later.
- Make it safe and remove. We isolate the system, disconnect and remove the panels, optimisers if fitted, and the mounting rails and roof hooks.
- Store the panels safely, labelled and protected, usually on site.
- Your roofer does the roof work.
- Refit. We fit new or existing roof hooks to suit the new roof, refit the rails and panels, and reconnect.
- Test and hand back. We test the panel strings and the inverter, check it’s generating and that the monitoring is back online, and give you the test results.
Storage
How panels should be handled and stored.
Panel makers say how their panels should be handled and stored. LONGi’s manuals, for example, say:
- Two people should lift and carry each panel, never by the junction box or cables.
- Don’t stand or walk on panels, or put heavy or sharp objects on them.
- Keep them somewhere dry, ventilated and sheltered from rain, on dry, well-drained ground.
- Keep connectors clean and dry. A wet or dirty connector mustn’t be connected.
- Don’t join connectors of different brands or models.
- Don’t drill holes in the frame.
LONGi’s storage advice is written mainly for new, packed panels, but it shows the care panels need while they’re off the roof.
Scaffold and timings
Scaffold and timings.
- Safe access is needed. HSE says sloping roofs need scaffolding to stop people or materials falling from the edge. Most roof jobs have a scaffold up anyway. If yours doesn’t, we can arrange scaffolding.
- We agree the timings with you and your roofer, so the panels come off at the start and go back on as soon as the roof is finished.
- How long it takes depends on the size of the system, the roof and access.
Feed-in tariff
Your feed-in tariff.
- Taking panels off for roof repairs and putting them back doesn’t in itself affect your FIT accreditation, Ofgem says, though it looks at each case on its own facts.
- Take a generation meter reading before the panels come off and after they’re back on. Ofgem says FIT payments can’t be based on estimated readings, so take a reading before and after the work. If you miss a scheduled reading, tell your FIT supplier. See feed-in tariff meter readings.
- If a panel is damaged and has to be replaced, a close match keeps the capacity the same. Ofgem says you must tell your FIT supplier if the total capacity changes. See replacing a single solar panel.
Paperwork
Your MCS certificate, insurer and panel warranty.
Check these before the roof work starts.
- Your MCS certificate. It records the solar PV equipment fitted. If details such as the products or capacity change, MCS says the certificate can be amended, and to ask your original installer first.
- Your home insurer. Insurers’ own guides, such as Ageas’s, say to tell your insurer before replacing a roof because of the risk of water damage, and that a claim could be reduced or refused if they didn’t know about the work. Aviva says to contact your insurer before structural work starts.
- Your manufacturer’s warranty. LONGi says not following its manual may void its warranty, and that drilling the frame invalidates it.
While it’s off
A good time to.
- Fix any faults found in the first check.
- Fit bird proofing, while the panels are off or the scaffold is up. See bird proofing.
- Replace an old inverter, or plan for a battery. See how long do solar inverters last?
How we help
How we help.
We remove and refit solar panels for roof work on systems fitted by any installer, across England, Wales and southern Scotland. We check the system before it comes off, store and refit it, test it and hand it back working. You get a clear written quote before any work starts.
Sources: HSE, Roof work; Ofgem, Guidance for FIT Generators (version 19, April 2026) and FIT: treatment of replacement generating equipment (December 2021); MCS, MCS certificate queries; LONGi, PV module user manual and unpacking, handling and storing guide; Ageas and Aviva home insurance guides.
Questions
The things people ask before they ring.
Not answered here? Call 0800 156 0191, Monday to Friday, 9:00am–5:00pm.
Can a roofer remove solar panels?
A roofer can work around them, but the panels should be disconnected, removed, refitted and tested by a solar engineer. They stay live in daylight, and poor reconnection can cause faults.
How long does it take to remove and refit solar panels?
How long each visit takes depends on the size of the system, the roof and access. The roof work happens in between.
Do I need scaffolding?
Usually, yes. HSE says sloping roofs need scaffolding to work safely at the edge. If you’re having roof work done, there’s normally a scaffold up already, and we time our visits around it.
Will removing my solar panels affect my feed-in tariff?
It shouldn’t, if the same panels go back on. Ofgem says temporary removal for roof repairs doesn’t in itself affect accreditation, though each case is reviewed individually. Take a meter reading before and after, and tell your FIT supplier if you miss a reading. If the capacity changes because a panel is replaced, tell them that too.
Does home insurance cover solar panel removal and refit?
If the roof work is part of an insurance claim, such as storm damage, the cost of removing and refitting the panels may be included. Check with your insurer before the work starts.
Can I take my solar panels with me if I move house?
Ofgem says FIT accreditation is tied to the site. If the panels are moved to a new property, they’re no longer eligible for FIT payments.
What if my solar panels are removed and not put back?
Ofgem says if the whole system is permanently removed, it’s decommissioned and FIT accreditation ends, and you must tell your FIT supplier. If only some panels come off for good, accreditation continues, but you must report the lower capacity.
Do I need a new MCS certificate after a refit?
We couldn’t find an MCS rule saying one is needed. MCS says certificate details can be amended if they change, through your original installer first. If the same panels go back, they shouldn’t change.
Ready when you are
Having roof work done?
We’ll call you back to talk it through, and you get a clear written quote before any work starts. Mon–Fri 9:00am–5:00pm.

