Installation · Guide
Solar diverters: heat your hot water with spare solar
A solar diverter, such as a Solar iBoost+ or a myenergi eddi, sends the solar electricity your home isn’t using to your immersion heater, so it heats your hot water instead of going to the grid. A sensor clipped around your incoming mains cable spots the spare power, and the diverter feeds the heater just that much until its thermostat says the tank is hot. Already have one that’s stopped working? See solar iBoost not working.
Mon–Fri 9:00am–5:00pm · Clear written quote before any work starts
Talk to us about solar, batteries or repairs.
Call 0800 156 0191, Monday to Friday, 9:00am–5:00pm, or send us a message through our contact page.
MCS certified
NAPIT registered
TrustMark approved
Fully insured
England, Wales & southern Scotland
How it works
How a solar diverter works.
Here’s how it works, what you need, and when it’s worth having.
- It watches your export. A sensor on your electricity supply sees when the panels are making more than the house is using.
- It sends the surplus to the immersion heater, turning the heater up and down to match the spare power, so you don’t draw from the grid to do it.
- When the water is hot, or there’s no spare solar, it stops, and the surplus is exported as normal.
- Some diverters can also feed a second heater, such as another immersion heater or a storage heater, depending on the model.
What you need
What you need.
- A hot water cylinder with an immersion heater. A diverter heats water stored in a tank, so it doesn’t work with a combi boiler, which has no tank.
- Solar panels that often make more than you use during the day. The bigger the surplus, the more it can divert.
- Space near the fuse board or cylinder for the diverter and its sensor, and fitting by a qualified electrician. See solar panel electrician.
Compatibility
Heat pumps and unvented cylinders.
Some setups need extra care.
- Thermostats. Marlec and myenergi say the immersion needs a working mechanical thermostat, with no timers or electronic controls between the diverter and the heater.
- Heat pumps. myenergi says most heat pumps switch the immersion on now and then to kill Legionella. Its eddi manual shows how the heat pump can keep doing this through an add-on relay board, and how the heat pump can take over when there’s more spare solar.
- Unvented cylinders. In England, Approved Document G says these need at least two independent safety devices besides the thermostat, such as a non-self-resetting energy cut-out and a temperature relief valve. Marlec tells electricians to test the immersion and thermostat first.
Diverter stopped heating? See solar iBoost not working.
Worth it?
Is a solar diverter worth it?
It depends on three things:
- How you heat your water now. If an immersion heater or electric heating does it, a diverter saves more. If a gas or oil boiler does it, Marlec suggests setting the boiler’s hot water to come on later in the day, so the diverter can heat the tank first.
- What you’re paid for export. Every unit you divert is a unit you don’t export. If your Smart Export Guarantee rate is high, exporting can be worth more than heating water. If it’s low, diverting usually wins.
- The time of year. Most of the benefit comes from spring to autumn. In winter there’s often little spare solar to divert. See do solar panels work in winter?
Diverter or battery
Diverter or battery?
- A battery stores spare solar as electricity to run the house in the evening. See what size solar battery do I need?
- A diverter stores spare solar as hot water. It’s a smaller, simpler add-on.
- You can have both. With the right settings, the battery fills first and the diverter takes what’s left over.
Battery first
Diverter and battery: which goes first?
Both want the same spare solar, so the settings decide.
- Solar iBoost+. Marlec says it starts diverting once export passes 100W, so a battery that starts charging below that fills first. On units from May 2019, that level can go up to 500W.
- eddi with an AC-coupled battery. myenergi says the two can compete, with “somewhat unpredictable” results, unless an extra sensor on the battery sets priority.
- eddi with a hybrid battery. myenergi recommends a 50W or 100W export margin to put the battery first.
- Two clamps. Marlec advises keeping the battery’s sensor and the iBoost+ clamp about 10cm apart.
Once the battery is full, the diverter takes what would otherwise be exported.
FIT and export
Feed-in tariff and export payments.
- If you’re on the feed-in tariff with deemed export, you’re paid for export on an estimate, 50% of what you generate for solar PV, rather than a meter reading. Some suppliers now switch homes with a smart meter to metered export, so check which you’re on. Diverting doesn’t change your generation, so it doesn’t change your FIT payments.
- If your export is metered, for example on a Smart Export Guarantee tariff, diverting means you export less, so you’re paid for less export. That’s the trade-off to weigh. See feed-in tariff rates 2026/27.
How we help
How we help.
We fit solar diverters for homes with solar panels, whoever installed the panels, across England, Wales and southern Scotland. We check your hot water system and how much spare solar you have, tell you honestly whether a diverter, a battery or both makes sense, and give you a clear written quote before any work starts.
Sources: Marlec (Solar iBoost+ manuals and FAQs), myenergi (eddi manuals), Energy Saving Trust, Ofgem FIT guidance for generators, DESNZ FIT determinations (year 17), GOV.UK Approved Document G and British Gas FIT.
Questions
The things people ask before they ring.
Not answered here? Call 0800 156 0191, Monday to Friday, 9:00am–5:00pm.
What is a solar diverter?
A device that sends the solar electricity your home isn’t using to your immersion heater, instead of exporting it to the grid. It turns spare solar into hot water.
Does a solar diverter work with a combi boiler?
No. A diverter heats water in a hot water cylinder through its immersion heater. A combi boiler has no tank, so there’s nothing to divert to.
Is a solar diverter worth it?
It usually is if you heat water with electricity, have plenty of spare solar and a low export rate. If you heat water with gas and get a good export rate, the saving is smaller.
Will a solar diverter affect my feed-in tariff?
Not if your export is deemed. Deemed export is worked out from your generation, and the Energy Saving Trust says deemed export doesn’t change when you add storage. If your export is metered, you’ll be paid for less export.
Is a diverter better than a battery?
They do different jobs. A battery stores spare solar to run the house later. A diverter turns spare solar into hot water and is simpler. Some homes with a battery add a diverter to use what’s left.
Can I still heat water with a solar diverter when there’s no sun?
Yes. Marlec says each press of the iBoost+ Boost button adds 15 minutes of grid heating, up to two hours, and it has a timer for night-time rates. The eddi has boost timers too.
Where is a solar diverter’s sensor fitted?
Around the incoming cable at your electricity meter, so it sees everything you import and export. Your electrician fits it.
Will a smart meter end my deemed FIT export?
It can. Ofgem lists having no export meter, “including a smart meter”, as an example of when deemed export applies, and British Gas now uses smart meter export readings instead. Then diverting means you’re paid for less export, so check with your supplier.
Ready when you are
Thinking about a solar diverter?
We’ll call you back to talk it through, and you get a clear written quote before any work starts. Mon–Fri 9:00am–5:00pm.

